Compatibility checks
Crossprobe checks connected parts against each other by rules: signals that cross from one supply rail to another, and I²C buses without sensible pull-ups. No model is involved. The AI review and the MCP server read the same results through check_compatibility.
Beta: Two kinds of check exist today, supply rail crossings and I²C pull-ups. A finding without a pinned datasheet row is a condition to verify in the datasheet, not a verdict.
Where to find them
Open the AI tab in the inspector. The Compatibility section above the review form shows the findings live from the design, with a count of how many there are to check, or "nothing found". Each finding has a severity, an explanation, and the parts and nets involved; choose one to select it in the views.
The AI design review and the MCP server get the same results through the check_compatibility tool.
How a part's supply rail is found
A part's supply rail is the voltage its power-input pins' net names promise, such as +3V3, +5V or VBUS. A part on several rails, or on a rail the name doesn't give, is skipped rather than guessed. Name your power nets with their voltage to get the most out of these checks.
Supply rail crossings
A signal net is flagged when:
- it is driven from a higher rail into an input on a lower rail. Check the input's absolute maximum rating, or whether it is 5 V tolerant;
- it is driven from a rail below 0.7 × VDD of the receiver. Check the receiver's VIH.
I²C nets are handled by their own check.
I²C pull-ups
SDA and SCL nets are flagged when they have:
- no resistor to a named rail;
- a parallel pull-up under 1 kΩ;
- a pull-up to a rail above a connected device's own supply.
Pinned datasheet ratings
Without datasheet data, the checks can only tell you what to look up. When you pin datasheet evidence to a part, they use it:
- Open the part's datasheet in the Datasheet tab.
- Find the voltage row under an Absolute maximum ratings or Recommended operating conditions heading.
- Choose Pin to part.
Pinned voltage rows are read as printed. A rail crossing into a pin with a pinned absolute maximum becomes an error when it exceeds that rating, and an info note when it is within it. The part's supply rail is also checked against its pinned absolute maximum and operating range. Each such finding quotes the row and the page it rests on. Rows pinned under other headings are ignored.
Limits
- Rails come from net names, not from measurements. A net called
+3V3is taken to be 3.3 V. - Parts with more than one supply rail are skipped.
- The checks don't read datasheets on their own. Only rows you pinned are used.